Description
ASCO 100-Amp Automatic Transfer Switch 100-Amp ATS Non-Service Rated NEMA 1 Indoor Only Residential or Light Commercial 100 Amp Transfer Switches ASCO 185 Series The Non-SE Rated ASCO 100 Amp Generator Transfer Switch Powers only essential or critical loads located in a subpanel separate from the main circuit breaker panel. During a power outage, the 100 Amp Automatic Transfer Switch disconnects the essential load panel from the main panel and provides power to the subpanel from the generator. Only the essential and critical loads connected to circuit breakers in the subpanel receive power. The NEMA 1 Steel cabinet is suitable for indoor installation. ASCO 100-Amp Automatic Transfer Switch Series 185 NON-SER NEMA 1 | 99714-365 100 Amp Automatic Transfer Switch Asco Transfer Switches make sure the power stays on when utility power fails. When utility power returns, the ASCO ATS switches the home or business back to utility power and begins generator cool-down. Compatible with any two-wire start system, The Asco 100 Amp Automatic Transfer Switch monitors the utility power 24/7. When an outage occurs or power quality falls below an acceptable level, the transfer switch starts the generator and waits as the engine warms and the speed stabilizes. Once the generator is ready, the ATS isolates the utility from the subpanel and supplies generator power to the home or business. 100 Amp Transfer Switch The time from power failure to restoration is typically less than 30 seconds. Automatically switches back to utility power when it returns. Generator cool-down cycle before shutdown. User friendly control panel. Not Rated for Use as a Main Disconnect. NEMA 1 steel Enclosure rated for indoor installation. ASCO 185 Features Power Status LEDs for Utility and Generator and Transfer Switch Position. Double Throw Contacts with Mechanical Locking Isolate Utility from Generator UL-1008 Listed and Meets NEC Article 702 Requirements 1 or 3 second time delay following outage before startup. Compatible with any two-wire start generator. ASCO 185 100 Amp Transfer Switch Recommended Accessories The ASCO Strip Heater is recommended for extremely cold climates to prevent condensation from freezing inside the transfer switch. A frozen switch may not transfer the load to the generator during a power outage. The Strip Heater is operated by a thermostat and requires an external 120-Volt source. Available as a kit only available for mounting by the end user. The 14A/14B auxiliary contacts indicate the position of the main contacts. One contact each for the normal and emergency positions. Available as a kit only for mounting by the end user in 100-Amp, 200-Amp, and 230 Amp ASCO 185 Transfer Switches. ASCO 100-Amp Automatic Transfer Switch Series 185 NON-SER NEMA 1 | 99714-365 Product Specifications Model Model Number; 185A2100F4C Manufacturer; ASCO Transfer Switches Rated Amps; 100 Amps Voltage; 120/240 Volts Single Phase Enclosure; NEMA 1 UL Listed; UL-1008 and UL-50 Type; Automatic Transfer Switch Transfer Switch Model; 185A2100F4C Features Weight; 44 Dimensions; 14.25W x 8.25D x 24H inches Warranty Information Consumer Warranty; ASCO 2-Year Limited Warranty Commercial Warranty; ASCO 2-Year Limited Warranty Transfer Switches Transfer Switch Model; 185A2100F4C Transfer Switch Amps; 100 Amps Ats Poles; 2 Transfer Switch Weight; 44 Pounds
